3D Multilateral Diamond Candle Mold

(1 customer review)

$9.50

This mold is a 3D cube Silicone mold that is perfect for creating individual bars of soap or cool candles. The mold makes 1 cube and is made of silicone for easy release.

Mold Dimensions: 5.7cm x 6.0 cm

In stock

    Description

     

    3D Multilateral Diamond Candle Mold

    This 3D Multilateral Diamond Mold is easy to use and is perfect for soap or candle making. The silicone mold is soft and easy to use and makes a Diamond faced 3D cube. The molds are easy release and simple to clean.

    Mold Dimensions: 6cm x 7cm

    Helpful Product Information:
    Material: Silicone Style: 3D Diamond Cube
    Height: 4.5cm Bar Length: 6.0cm
    Bar Width: 7.0cm Max Temperature: 210ºC
    Directions:

    Melt & Pour Soap: Pour melted soap into silicone mold.  Allow soap to cool at room temperature until hard. Carefully remove soap from mold by gently pulling the sides away from the soap, and then push on the bottom of the mold until the soap starts to release. Grab hold of the soap and carefully pull out of the mold.

    Candle: Pour melted soy wax into silicone mold. If you want to thread a wick through the mold put a pin pick in the silicone and then push the wick through. Wrap some blue tack around the outside of the wick to stop it from leaking.

    Care:
    Hand wash mold in warm, sudsy water.

    1 review for 3D Multilateral Diamond Candle Mold

    1. Debbie Fry

      I have made quite a lot of candles using this mould. It’s so much fun, especially if you use different colours for each layer. Very easy to use and get the candle out. 100% recommended this product

    Add a review

    Your email address will not be published. Required fields are marked *