Birthday Lettering Soy Melt Mold

$9.00

In stock

    Description

    Product Description:

    With this silicone mold you can make your own birthday lettering  soy decorations or melts. The birthday lettering silicone mold is designed for making wax decorations and could be used for wax melts in a small oil burner. When the scented melt heats up, it fills the room with a lovely scented aroma of your choice. Some fragrances that would work a treat with this mold could be Chocolate and Roses and Champagne, you can also colour your melts so get creative and have fun!

    Helpful Product Information:
    Material: Silicone Style: birthday lettering
    Bar Cavities: 24 Mold Total Capacity (ml): 100
    Bar Depth: 7mm Bar Length: 210mm
    Bar Width: 115mm Max Temperature: 240 degrees Celsius
    Directions:

    Soy Wax:
    If using for decoration on a candle then you can use the same soy wax as you have in your container.

    Soy Melts:
    Use either Golden Wax 5715 or All Seasons A27 Soy Wax. Heat soy wax to the manufacturers recommended temperature and add your fragrance, stir for two minutes and lower the pour temperature to around 50-55 degrees C before pouring to your mould. Let the wax set fully before gently popping your melts from the mould.

    Melt & Pour Soap: Pour melted soap at a temperature no hotter than 57ºC into mold. Cool until soap has hardened. Remove soap from mold. For easier unmolding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.

    Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

    Care:
    Hand wash mold in warm, sudsy water.

     

     

    Reviews

    There are no reviews yet.

    Be the first to review “Birthday Lettering Soy Melt Mold”

    Your email address will not be published. Required fields are marked *