Silicone Soap Mold


Sorry this item is currently out of stock!

Please enter your email address below and we'll email you when it is back in stock.

Out of stock

Send me product alerts
SKU: 01325 Category: Tags: , ,


Product Description:

Serious soap makers will know the value and convenience Christmas silicon molds offer.

Helpful Product Information:

Christmas mould is a 4 cavity.

Outer measures: 190mm x 135mm x 40mm.

Inner measures: 85mm x 55mm x 35mm. approx.

Bars weight :  100g approx.


Melt & Pour Soap: Pour melted soap at a temperature no hotter than 57ºC into mold. Cool until soap has hardened. Remove soap from mold. For easier un-molding, place into freezer for 30 minutes, and then immerse bottom of the mold in hot water for a few moments. Do not use cooking spray to coat mold.

Cold Process Soap: Coat the mold with cooking spray. Pour soap at trace into mold. After 24 hours, flip mold over onto a clean surface. Gently push the back of the mold until the soap begins to release then pull the soap out of the mold with a gloved hand. Allow soap to cure for 4-8 weeks. Note that some CP soap recipes may require a week to harden enough to remove from the mold. If this is the case with your recipe, we recommend adding sodium lactate to your recipe to assist with creating a harder bar faster.

Lotion Bars: Pour melted lotion bar mixture into mold cavities at a temperature no hotter than 57ºC. Allow mixture to solidify. Flip mold over onto clean surface. Gently push back of mold until lotion bar begins to release then pull bar out of mold.

Care Instructions:

OWL_CandleCreations_FSWash molds in warm, sudsy water. Please avoid the dishwasher.




There are no reviews yet.

Be the first to review “Silicone Soap Mold

Your email address will not be published. Required fields are marked *

Remove all
<< >>